The influence of woven fabric geometry on its surface-mechanical propertiesPenko, Tadeja (Avtor) Dobnik-Dubrovski, Polona (Avtor) fabric engineeringwoven fabric geometrytype of weaverelative fabric densitysurface roughnesscoefficient of frictioncotton woven fabricsThis study presents the influence of the type of weave and relative fabric density on surface roughness and the coefficient of friction in raw cotton woven fabrics. Relative fabric density, which represents how full a fabric is compared to the maximum packing density allowed by its weave, provides a more accurate basis for comparison than absolute fabric density. Analysis revealed that both the type of weave and relative fabric density have a statistically significant effect on surface roughness, while neither factor significantly impacts the coefficient of friction. Notably, increasing relative fabric density consistently reduces surface roughness in plain, 2/2 twill, and, to some extent, 5-end satin fabrics, with plain fabrics showing the highest roughness overall. At high densities, 2/2 twill fabrics exhibit greater structural stability, yielding smoother surfaces than 5-end satin fabrics, reversing trends detected at lower densities. Furthermore, the relationship between surface roughness and friction was decoupled in plain and 2/2 twill fabrics—specifically, increased density leads to smoother surfaces and higher friction. 5-end satin fabrics were unique in showing a simultaneous reduction in both surface-mechanical properties as fabric density increased. These findings highlight that relative fabric density is a critical parameter for engineering fabrics with tailored performance properties.MDPI20252025-12-04 15:54:54Članek v reviji96159sl