20.500.12556/DKUM-25931 New approach to uncertainty evaluation in the calibration of gauge block comparators Gauge blocks (GBs) are being calibrated by two methods: interferometric calibration and calibration by mechanical comparison to reference GB. While interferometric method represents primary level, comparison is more suitable for calibrating industrial GBs because of lower costs and shorter calibration time. Although no significant changes in equipment happened in last decade, improvements in mechanical comparison are on-going. In addition to the uncertainty of the reference GB calibration, uncertainty of the GB comparator is the most important contribution to total uncertainty of the mechanical calibration. The article introduces a new approach for evaluating the uncertainty of GB comparator calibration. The uncertainty budget and results of analytical and experimental evaluation of all contributions are presented. This approach results in lower end-effect uncertainty and a slightly higher length dependent uncertainty, in comparison with the uncertainty evaluation procedure as described in EA document EA-10/02. measurements calibration measuring uncertainty gauge block comparator CMC mechanical comparison tehnološke meritve kalibriranje merilna negotovost etaloni mehanska primerjava true false false Angleški jezik Angleški jezik Neznano 2012-05-31 11:29:36 2012-05-31 11:29:36 2022-04-15 03:40:25 2023-12-31 03:28:42 2007 0 0 0000-00-00 NiDoloceno NiDoloceno NiDoloceno 0000-00-00 0000-00-00 0000-00-00 53.089 11393558 0263-2241 URN:SI:UM:DK:KBBLKUTI http://dx.doi.org/10.1016/j.measurement.2006.09.010 1 https://dk.um.si/Dokument.php?lang=slv&id=34819 Fakulteta za strojništvo 0 0 0