20.500.12556/DKUM-84563 Konstruiranje pločevinastega hrbta magistrsko delo Design of a sheet metal back Zaradi sprememb standardov ter predpisov, ki jih kot podjetje moramo spoštovati, se je pojavila potreba po spremembah materialov ter konstrukcij nekaterih komponent. Ena izmed komponent je hrbet. Trenutno uporabljamo kartonasto ploščo s tanko prevleko aluminija, ki je do zdaj zadoščala vsem potrebam, spremeniti pa smo morali tudi material. Material smo spremenili iz kartona na kovino, kar je povzročilo še spremembo na konstrukciji hrbta, ki je morala biti čisto drugačna. Novi hrbet bomo sprva skonstruirali, potem pa naredili analize s pomočjo programskih orodij, izdelali bomo vzorce ter jih preizkusiti na aparatu. Due to changes in standards and regulations that we as a company must comply with, there was a need to change the materials and constructions of some components. One of the components is the Back. We are currently using a cardboard panel with a thin coating of aluminum, which until now has been sufficient for all needs, but we had to change the material. We changed the material from cardboard to metal, which entailed a change in the construction of the back, which had to be completely different. We will initially construct the new back, then analyze it with the help of software tools, create samples and test them on the device. hladilnik razvoj Siemens NX analiza CAE cooler development Siemens NX CAE analysis true true false [I. Vukovič] Slovenski jezik Angleški jezik Magistrsko delo/naloga 2023-06-21 08:35:34 2023-07-19 11:43:36 2023-09-01 03:10:51 0000-00-00 00:00:00 2023 0 Maribor 0 Maribor 1 spletni vir (1 datoteka PDF (IX, 38 f.)) 0000-00-00 NiDoloceno NiDoloceno NiDoloceno 0000-00-00 0000-00-00 0000-00-00 2026-06-30 62-214-11(043.2) 162795011 Fakulteta za strojništvo 0 0 1