| Naslov: | Using LabVIEW software for development of new data acquisition software |
|---|
| Avtorji: | ID Reibenschuh, Marko (Avtor)
ID Čuš, Franc (Avtor)
ID Župerl, Uroš (Avtor) |
|---|
| Datoteke: |  http://www.mdesign.ftn.uns.ac.rs/pdf/2012/no3/157-160.pdf
|
|---|
| Jezik: | Angleški jezik |
|---|
| Vrsta gradiva: | Delo ni kategorizirano |
|---|
| Tipologija: | 1.01 - Izvirni znanstveni članek |
|---|
| Organizacija: | FS - Fakulteta za strojništvo
|
|---|
| Opis: | LabVIEW enables programing and development of different interfaces for monitoring. Because of worldwide increasing demands for condition monitoring and demands to increase productivity, a new user interface for data acquisition is developed and applied to gather data and information during cutting. Other possibilities for implementing the method into production process are also researched. To monitor a high speed process, the use of high speed camera is inevitable.. This paper presents preliminary development, tests and result. |
|---|
| Ključne besede: | monitoring, milling, data acquisition, LabVIEW |
|---|
| Leto izida: | 2012 |
|---|
| Št. strani: | str. 157-160 |
|---|
| Številčenje: | Vol. 4, no. 3 |
|---|
| PID: | 20.500.12556/DKUM-50180  |
|---|
| UDK: | 62-585.9 |
|---|
| COBISS.SI-ID: | 16415766 |
|---|
| ISSN pri članku: | 1821-1259 |
|---|
| NUK URN: | URN:SI:UM:DK:VSLRI96P |
|---|
| Datum objave v DKUM: | 10.07.2015 |
|---|
| Število ogledov: | 1624 |
|---|
| Število prenosov: | 67 |
|---|
| Metapodatki: |    |
|---|
| Področja: | Ostalo
|
|---|
|
:
|
Kopiraj citat |
|---|
| | | | Skupna ocena: | (0 glasov) |
|---|
| Vaša ocena: | Ocenjevanje je dovoljeno samo prijavljenim uporabnikom. |
|---|
| Objavi na: |  |
|---|
Postavite miškin kazalec na naslov za izpis povzetka. Klik na naslov izpiše
podrobnosti ali sproži prenos. |
