Energy saving cooling-unit for plastic moulding machine

Lovrec, Darko; Tič, Vito

| | SLO | ENG | Piškotki in zasebnost

Večja pisava | Manjša pisava

Prva stran > Izpis gradiva

Izpis gradiva

Naslov:	Energy saving cooling-unit for plastic moulding machine
Avtorji:	ID Lovrec, Darko (Avtor) ID Tič, Vito (Avtor)
Datoteke:	http://www.dlib.si/details/URN:NBN:SI:doc-2U7JCMWH
Jezik:	Angleški jezik
Vrsta gradiva:	Delo ni kategorizirano
Tipologija:	1.01 - Izvirni znanstveni članek
Organizacija:	FS - Fakulteta za strojništvo
Opis:	Compressed air is one of the major sources of energy consumption and also one of the most expensive types of energy. Consequently, special attention must be paid to its rational use. This is especially important in cases where compressed air is blowed into an "empty" space. All cleaning and cooling processes using compressed air are typical examples of such applications. They are the most wasteful consumers of compressed air. Measures to minimize air consumption in such cases are presented in the paper. The highly efficient cooling unit for plastic moulding machines has been designed and optimized based on CFD simulation, and then produced using RP/RM (Rapid Prototyping / Manufacturing) manufacturing technology. The developed and specially designed nozzle-system was used for cooling purposes during plastic canister manufacturing. The previously-used conventional cooling system had so far been recognized as the most wasteful compressed air consumer in the company. The newly-designed air-efficient cooling unit, with increased capacity for cooling air, allows for up to 50% energy savings regarding compressed air.
Ključne besede:	compressed air, cooling, blow moulding machine
Založnik:	= Association of Mechanical Engineers and Technicians of Slovenia et al.
Leto izida:	2011
Št. strani:	str. 83-90
Številčenje:	Vol. 57, no. 2
PID:	20.500.12556/DKUM-52239
UDK:	621.56
COBISS.SI-ID:	14811926
DOI:	10.5545/sv-jme.2010.082
ISSN pri članku:	0039-2480
NUK URN:	URN:SI:UM:DK:LVTEKF8B
Datum objave v DKUM:	10.07.2015
Število ogledov:	1660
Število prenosov:	109
Metapodatki:
Področja:	Ostalo
:	Kopiraj citat

Skupna ocena:	(0 glasov)
Vaša ocena:	Ocenjevanje je dovoljeno samo prijavljenim uporabnikom.
Objavi na:

Postavite miškin kazalec na naslov za izpis povzetka. Klik na naslov izpiše podrobnosti ali sproži prenos.

Gradivo je del revije

Naslov:	Strojniški vestnik
Skrajšan naslov:	Stroj. vestn.
Založnik:	Zveza strojnih inženirjev in tehnikov Slovenije [etc.], = Association of Mechanical Engineers and Technicians of Slovenia [etc.]
ISSN:	0039-2480
COBISS.SI-ID:	762116

Sekundarni jezik

Jezik:	Slovenski jezik
Ključne besede:	stisnjen zrak, hlajenje, pihanje plastike

Komentarji

Dodaj komentar

Za komentiranje se morate prijaviti.

Komentarji (0)

0 - 0 / 0

Ni komentarjev!

Nazaj