Poenostavljena metoda upoštevanja dinamičnih histereznih izgub v modelu enofaznega transformatorja

Deželak, Klemen; Klopčič, Beno; Štumberger, Gorazd; Dolinar, Drago

| | SLO | ENG | Piškotki in zasebnost

Večja pisava | Manjša pisava

Prva stran > Izpis gradiva

Izpis gradiva

Naslov:	Poenostavljena metoda upoštevanja dinamičnih histereznih izgub v modelu enofaznega transformatorja
Avtorji:	ID Deželak, Klemen (Avtor) ID Klopčič, Beno (Avtor) ID Štumberger, Gorazd (Avtor) ID Dolinar, Drago (Avtor)
Datoteke:	http://www.dlib.si/details/URN:NBN:SI:DOC-V272QFXV
Jezik:	Slovenski jezik
Vrsta gradiva:	Delo ni kategorizirano
Tipologija:	1.01 - Izvirni znanstveni članek
Organizacija:	FERI - Fakulteta za elektrotehniko, računalništvo in informatiko
Opis:	V članku je obravnavana poenostavljena metoda upoštevanja dinamičnih histereznih izgub v modelu enofaznega transformatorja. Magnetno nelinearna karakteristika železnega jedra je upoštevana v obliki tabele, vpliv histereze pa je zajet s premikanjem omenjene karakteristike v levo in desno. Poleg vpliva histereznih izgub je v modelu transformatorja upoštevan tudi vpliv vrtinčnih izgub. Podana je primedava izmerjenih in izračunanih tokov, in sicer tako za primer brez kot tudi z upoštevanjem vrtinčnih izgub.
Ključne besede:	enofazni transformatorji, železno jedro, histerezne izgube, vrtinčne izgube
Založnik:	Elektrotehniška zveza Slovenije
Leto izida:	2007
Št. strani:	str. 261-266
Številčenje:	Vol. 74, no. 5
PID:	20.500.12556/DKUM-52790
UDK:	621.3
COBISS.SI-ID:	11993878
ISSN pri članku:	0013-5852
NUK URN:	URN:SI:UM:DK:QHIU0PZJ
Datum objave v DKUM:	10.07.2015
Število ogledov:	2197
Število prenosov:	57
Metapodatki:
Področja:	Ostalo
:	Kopiraj citat

Skupna ocena:	(0 glasov)
Vaša ocena:	Ocenjevanje je dovoljeno samo prijavljenim uporabnikom.
Objavi na:

Postavite miškin kazalec na naslov za izpis povzetka. Klik na naslov izpiše podrobnosti ali sproži prenos.

Gradivo je del revije

Naslov:	Elektrotehniški vestnik
Založnik:	Strokovna zadruga koncesijoniranih elektrotehnikov
ISSN:	0013-5852
COBISS.SI-ID:	742916

Sekundarni jezik

Jezik:	Angleški jezik
Naslov:	A simplified method for consideration of dynamic hysteresis losses in a single-phase transformer model
Opis:	The paper deals with, a magnetically nonlinear dynamic model of a single-phase transformer where the effects of dynamic hysteresis losses and iron core losses to be accounted for by a simplified method. The existing simplified method [4] for considering dynamic iron core losses in the form of magnetizing curve B(H), displaced to the left and to the right by factor Hhist (22), is modified. It is now suitable to be used when the magnetizing curve of the iron-core material is not available, while the magnetically nonlinear characteristic y(i) of the entire device can be determined experimentally [7]. The characteristic y(i) can be given in the form of an approximation polynomial or in the form of a look-up table. A schematic presentation of the discussed single-phase transformer is shown in Figure 1. It is used as a basis for two different circuit models presented in sections 2.1 and 2.2. The first circuit model with neglected eddy-current losses is shown in Figure 2, while the second circuit model with the eddy-current losses are accounted for by the resistor RFo is shown in Figure 3. The corresponding magnetically nonlinear single-phase transformer dynamic models is given by sets of equations (1) to (11) and (12) to (20). In the first model, only the hysteresis losses can be accounted for while the second one can handle hysteresis and eddy current losses. Both models are completed by magnetically nonlinear characteristic y(i) of the tested transformer. Section 3 describes how the hysteresis losses can be accounted for by shifting an unique magnetically nonlinear iron - core characteristic given in the form of the magnetizing curve B(H) to the left and to the right by factor Hhist. The complete approach is explained in Figure 4 where fo denotes the unique characteristic B(H). Factor Hhist (22) is defined by the hysteresis factor Khist, actual flux density B and flux density in the last turning point Brev. Equations (23) to (25) show, how partial derivatives a&ao, needed in dynamic models (equations sets (1)-(1 1) and (12)-(20)), can be determined from characteristic B(H). Expressions (26) and (27) are used to determine characteristic VI(i) from the measured applied voltage and corresponding current under transformer no-load operation. Figure 5 shows a set of characteristics VI(i) in the form of hysteresis loops determined for different amplitudes of the applied voltage. The unique characteristic y(i) used in calculations is given by end points of individual hysteresis loops. Equations (28) to (31) are used to determine magnetic reluctances Rm or partial derivatives Mao from the end points of the individual hysteresis loops shown in Figure 5. Figure 6 shows the measured hysteresis loop a), unique y(i) characteristic b) and approximation of the hysteresis loop used to account for hysteresis losses c). A corresponding comparison of the measured and calculated currents is shown in Figure 7. Figure 8 shows that a better agreement the between measured and calculated currents can be achieved if hysteresis losses are accounted for in the transformer dynamic model together with the eddy-current losses.
Ključne besede:	single phase transformer, iron core, hysteresis losses, eddy - current losses

Komentarji

Dodaj komentar

Za komentiranje se morate prijaviti.

Komentarji (0)

0 - 0 / 0

Ni komentarjev!

Nazaj