| Naslov: | Artificial tooth and polymer-base bond in removable dentures: the influence of pre-treatment on technological parameters to the bond`s strength |
|---|
| Avtorji: | ID Pavlin, Martin (Avtor)
ID Rudolf, Rebeka (Avtor)
ID Jerolimov, Vjekoslav (Avtor) |
|---|
| Datoteke: |  http://www.dlib.si/details/URN:NBN:SI:DOC-NEG0TSQA
|
|---|
| Jezik: | Angleški jezik |
|---|
| Vrsta gradiva: | Delo ni kategorizirano |
|---|
| Tipologija: | 1.01 - Izvirni znanstveni članek |
|---|
| Organizacija: | FS - Fakulteta za strojništvo
|
|---|
| Opis: | The aim of this study was to evaluate the artificial tooth and polymerbase bond, and to measure any formatted gaps between tooth and base. Acrylic models were classified into four groups depending on the type of surface pre-treatment. A pre-treatment surface combining mechanical and chemical led to the highest bond strength between acrylic tooth and denture-base. The fore-mentioned pre-treatment had an influenced on gap formation with an average value of 68.250 micro m, which is 70 % of the gap for the untreated samples. Furthermore, the measured compressive strength was above 6000 N/mm2, yet only 3200 N/mm2 on the untreated samples. |
|---|
| Ključne besede: | artificial tooth, acrylic tooth, polymer base bond, dentistry |
|---|
| Leto izida: | 2008 |
|---|
| Št. strani: | str. 191-197 |
|---|
| Številčenje: | Vol. 55, no. 2 |
|---|
| PID: | 20.500.12556/DKUM-56135  |
|---|
| UDK: | 620.1:61 |
|---|
| COBISS.SI-ID: | 12355094 |
|---|
| ISSN pri članku: | 1408-7073 |
|---|
| NUK URN: | URN:SI:UM:DK:TLIZURIG |
|---|
| Datum objave v DKUM: | 21.12.2015 |
|---|
| Število ogledov: | 1224 |
|---|
| Število prenosov: | 42 |
|---|
| Metapodatki: |    |
|---|
| Področja: | Ostalo
|
|---|
|
:
|
Kopiraj citat |
|---|
| | | | Skupna ocena: | (0 glasov) |
|---|
| Vaša ocena: | Ocenjevanje je dovoljeno samo prijavljenim uporabnikom. |
|---|
| Objavi na: |  |
|---|
Postavite miškin kazalec na naslov za izpis povzetka. Klik na naslov izpiše
podrobnosti ali sproži prenos. |
