| Naslov: | Evaluation of measurement uncertainty contributions in ring gauge calibration |
|---|
| Avtorji: | ID Ačko, Bojan (Avtor)
ID Tompa, Jasna (Avtor)
ID Klobučar, Rok (Avtor) |
|---|
| Datoteke: |  text23-4_697.pdf (1017,13 KB)
MD5: A675CF2696A081FE7CA37049EF9BAF77
 https://www.ijsimm.com/Full_Papers/Fulltext2024/text23-4_697.pdf
|
|---|
| Jezik: | Angleški jezik |
|---|
| Vrsta gradiva: | Članek v reviji |
|---|
| Tipologija: | 1.01 - Izvirni znanstveni članek |
|---|
| Organizacija: | FS - Fakulteta za strojništvo
|
|---|
| Opis: | Measurements are of paramount importance in industry and other areas of importance to society. They are used to determine the characteristics of processes and products, to control and regulate processes, to decide on the acceptable quality of products, etc. To ensure the quality of measurements, we have to calibrate measuring devices regularly. In our laboratory – the holder of the national length standard, we mainly calibrate high-precision standards from accredited laboratories. As the demands on the accuracy of measurements are constantly increasing, we are also forced to continuously improve the accuracy of our calibration procedures. This article presents the development of methods for calibrating the diameter of ring gauges, which represent an important standard for calibrating measuring instruments for measuring internal dimensions. The main objective of this development is to reduce the measurement uncertainty based on a scientific investigation of all influencing parameters. The presented study focuses in particular on the control and reduction of the influence of geometric anomalies of the calibrated rings on the measurement uncertainty during calibration. |
|---|
| Ključne besede: | measurement traceability, calibration, measurement uncertainty, error simulation |
|---|
| Status publikacije: | Objavljeno |
|---|
| Verzija publikacije: | Objavljena publikacija |
|---|
| Datum objave: | 01.12.2024 |
|---|
| Založnik: | DAAAM International Vienna |
|---|
| Leto izida: | 2024 |
|---|
| Št. strani: | str. 575-586 |
|---|
| Številčenje: | Vol. 23, no. 4 |
|---|
| PID: | 20.500.12556/DKUM-92007  |
|---|
| UDK: | 006.915 |
|---|
| COBISS.SI-ID: | 220108803 |
|---|
| DOI: | 10.2507/IJSIMM23-4-697 |
|---|
| ISSN pri članku: | 1726-4529 |
|---|
| Datum objave v DKUM: | 11.03.2025 |
|---|
| Število ogledov: | 159 |
|---|
| Število prenosov: | 12 |
|---|
| Metapodatki: |    |
|---|
| Področja: | Ostalo
|
|---|
|
:
|
Kopiraj citat |
|---|
| | | | Skupna ocena: | (0 glasov) |
|---|
| Vaša ocena: | Ocenjevanje je dovoljeno samo prijavljenim uporabnikom. |
|---|
| Objavi na: |  |
|---|
Postavite miškin kazalec na naslov za izpis povzetka. Klik na naslov izpiše
podrobnosti ali sproži prenos. |
