| | SLO | ENG | Piškotki in zasebnost

Večja pisava | Manjša pisava

Izpis gradiva Pomoč

Naslov:The influence of woven fabric geometry on its surface-mechanical properties
Avtorji:ID Penko, Tadeja (Avtor)
ID Dobnik-Dubrovski, Polona (Avtor)
Datoteke:.pdf textiles-05-00040.pdf (2,56 MB)
MD5: 873019CFC24936783FCF1C496E8A9153
 
URL https://www.mdpi.com/2673-7248/5/4/40
 
Jezik:Angleški jezik
Vrsta gradiva:Članek v reviji
Tipologija:1.01 - Izvirni znanstveni članek
Organizacija:FS - Fakulteta za strojništvo
Opis:This study presents the influence of the type of weave and relative fabric density on surface roughness and the coefficient of friction in raw cotton woven fabrics. Relative fabric density, which represents how full a fabric is compared to the maximum packing density allowed by its weave, provides a more accurate basis for comparison than absolute fabric density. Analysis revealed that both the type of weave and relative fabric density have a statistically significant effect on surface roughness, while neither factor significantly impacts the coefficient of friction. Notably, increasing relative fabric density consistently reduces surface roughness in plain, 2/2 twill, and, to some extent, 5-end satin fabrics, with plain fabrics showing the highest roughness overall. At high densities, 2/2 twill fabrics exhibit greater structural stability, yielding smoother surfaces than 5-end satin fabrics, reversing trends detected at lower densities. Furthermore, the relationship between surface roughness and friction was decoupled in plain and 2/2 twill fabrics—specifically, increased density leads to smoother surfaces and higher friction. 5-end satin fabrics were unique in showing a simultaneous reduction in both surface-mechanical properties as fabric density increased. These findings highlight that relative fabric density is a critical parameter for engineering fabrics with tailored performance properties.
Ključne besede:fabric engineering, woven fabric geometry, type of weave, relative fabric density, surface roughness, coefficient of friction, cotton woven fabrics
Status publikacije:Objavljeno
Verzija publikacije:Objavljena publikacija
Poslano v recenzijo:22.07.2025
Datum sprejetja članka:10.09.2025
Datum objave:24.09.2025
Založnik:MDPI
Leto izida:2025
Št. strani:17 str.
Številčenje:Vol. 5, iss. 4, [article no.] 40
PID:20.500.12556/DKUM-96159 Novo okno
UDK:677.017
COBISS.SI-ID:256570371 Novo okno
DOI:10.3390/textiles5040040 Novo okno
ISSN pri članku:2673-7248
Datum objave v DKUM:04.12.2025
Število ogledov:237
Število prenosov:11
Metapodatki:XML DC-XML DC-RDF
Področja:Ostalo
:
Kopiraj citat
  
Skupna ocena:(0 glasov)
Vaša ocena:Ocenjevanje je dovoljeno samo prijavljenim uporabnikom.
Objavi na:Bookmark and Share



Postavite miškin kazalec na naslov za izpis povzetka. Klik na naslov izpiše podrobnosti ali sproži prenos.

Gradivo je del revije

Naslov:Textiles : multidisciplinary open access journal in research and innovation of textiles
Skrajšan naslov:Textiles
Založnik:MDPI AG
ISSN:2673-7248
COBISS.SI-ID:54064387 Novo okno

Gradivo je financirano iz projekta

Financer:ARIS - Javna agencija za znanstvenoraziskovalno in inovacijsko dejavnost Republike Slovenije
Številka projekta:P2-0063-2022
Naslov:Konstruiranje celičnih struktur

Licence

Licenca:CC BY 4.0, Creative Commons Priznanje avtorstva 4.0 Mednarodna
Povezava:http://creativecommons.org/licenses/by/4.0/deed.sl
Opis:To je standardna licenca Creative Commons, ki daje uporabnikom največ možnosti za nadaljnjo uporabo dela, pri čemer morajo navesti avtorja.

Sekundarni jezik

Jezik:Slovenski jezik
Ključne besede:tekstilna tehnologij, inženiring, geometrija tkanih tkanin, vrsta tkanja, relativna gostota tkanine, hrapavost površin, koeficient trenja, bombažne tkanine


Komentarji

Dodaj komentar

Za komentiranje se morate prijaviti.

Komentarji (0)
0 - 0 / 0
 
Ni komentarjev!

Nazaj
Logotipi partnerjev Univerza v Mariboru Univerza v Ljubljani Univerza na Primorskem Univerza v Novi Gorici