| | SLO | ENG | Cookies and privacy

Bigger font | Smaller font

Show document Help

Title:Sprememba konstrukcije kokile za litje na nizkotlačnem livnem stroju
Authors:ID Avguštin, Martin (Author)
ID Ulbin, Miran (Mentor) More about this mentor... New window
Files:.pdf VS_Avgustin_Martin_2013.pdf (4,15 MB)
MD5: 1020A0A96285D1CA2E9E03B6730AB66F
 
Language:Slovenian
Work type:Bachelor thesis/paper
Typology:2.11 - Undergraduate Thesis
Organization:FS - Faculty of Mechanical Engineering
Abstract:Talum ulitki so prejeli obstoječo kokilo za ohišje stikala. Kokile v obstoječem stanju ni bilo možno zmontirati na obstoječ nizkotlačni livni stroj saj, vodila, vpenjalne plošče ne sovpadajo z vodili livnega stroja. Potrebna je bila izdelava konstrukcije da se izognemo vodilom nizkotlačnega livnega stroja ter izvesti preračun nove konstrukcije. V nadaljevanju je bila potrebna še analiza obremenitev, ki se pojavijo v konstrukciji. Najbolj pomembno pri nosilcu je, da za njegovo izdelavo porabimo čim manj finančnih sredstev zato, da nosilec zdrži obremenitev in da ga lahko čim enostavneje pritrdimo na stroj. Naprej je bil izdelan 3D model livnega stroja nato sledi izdelava 3D modela obstoječe konstrukcijske kokile. Na osnovi sestave obeh sklopov je bila izvedena optimalna predelava konstrukcije in numerična analiza konstrukcije. Kritične točke so bile dodatno preverjene s trdnostnim preračunom.
Keywords:Konstruiranje, dimenzioniranje, analiziranje, optimiranje.
Place of publishing:Maribor
Publisher:[M. Avguštin]
Year of publishing:2013
PID:20.500.12556/DKUM-42971 New window
UDC:621.74(043.2)
COBISS.SI-ID:17633814 New window
NUK URN:URN:SI:UM:DK:FCG7VFUH
Publication date in DKUM:18.12.2013
Views:2004
Downloads:255
Metadata:XML DC-XML DC-RDF
Categories:KTFMB - FS
:
Copy citation
  
Average score:(0 votes)
Your score:Voting is allowed only for logged in users.
Share:Bookmark and Share



Hover the mouse pointer over a document title to show the abstract or click on the title to get all document metadata.

Secondary language

Language:English
Title:Design modification of cast mould on low pressure molding machine
Abstract:The company Talum casting had received, an existing mold, for the housing of a switch. It was not possible to mount the mold on the existing low pressure-casting machine. Clamping panels did not coincide with the guides of the casting machine. A new construction was to avoid the guides of the low pressure-casting machine. The primary consideration for the construction is, to make it as cheap, as possible and that it can withstand the prescribed load. First a three dimensional model of casting machine has to be made following by a three dimensional model of the existing construction of the cast. To the construction of an assembly of the two models was numerical analysed. The critical points were additionally checked with a strength calculation.
Keywords:Construction, dimensioning, analyzing, optimising.


Comments

Leave comment

You must log in to leave a comment.

Comments (0)
0 - 0 / 0
 
There are no comments!

Back
Logos of partners University of Maribor University of Ljubljana University of Primorska University of Nova Gorica